Categories
Construction Encouraging wildlife and nature Shabbihaus retrofit Ventilation & fresh air

My Shabbihaus eco retrofit project part 4 living wall insulation

Dry air in the house is a good achievement but I have also been worrying about the pollution levels. Two of the three air intakes are located above the back garden and the front one has some good tree coverage between it and the road but it is still a busy traffic area. This made me look at some alternative ways of cleaning the air, I did some googling and came across the NASA research project on houseplants and their impact on air quality. Now before I go any further I do realise that these were controlled tests and we would also need a very large number of plants to get a big impact but I figure it can’t hurt and what I made looks great.

I have been keen to do something with reclaimed wood and also to add some extra insulation to the flank wall in the kids bedroom so I got a bit carried away here and produced this wall made from old pallets with 50mm of woodfibre insulation behind it. I was a bit nervous about this project as it has a bit more of a design impact than some of the other projects, it’s been in a while now though and I am so pleased with the outcome visually. 

The first thing we did was tour the streets collecting abandoned pallets. I found that ones that were slightly broken already were better as they are easier to dismantle than really well built ones. The kids really enjoyed the collection process and I also got them to stain some of the planks we extracted to add some variety to the wall.

Next step was to get hold of some wood fibre insulation, not so easy for small quantities but thanks to https://phstore.co.uk/ for arranging it for me, delivery costs almost the same as the insulation in small quantities but cheaper than elsewhere and charming service too. I then fixed some 50mm battens to the wall at 600mm and push fitted the insulation between. 

The next bit involved a nail gun so was great fun managed to charm the lady at Travis Perkins into giving me a discount and I was off. I fixed them in an offset pattern and tried to group similar widths of board together so it wasn’t too bumpy. 

Then we had to make shelves for the plants to grow on. I used the ‘dice’ from the pallets (technical term for the square bits that go in between the pallets) screwed into the wall to support shelves made from more pallet boards. These dice are pretty tough and tricky to drill through, one of them still has half a drill bit in it where it snapped. 

Once it was all up we put in the plants, I used Chinese evergreen, peace lily, some snake plants and a cutting from an old spider plant. I also put in a watering system! Well, I bought some globes that you fill up and they drip out over a couple of weeks, they are a bit inconsistent but a lot cheaper than some automated system. I top them up with waste water from kids water bottles and they are still growing nearly a year later.

Categories
Gadgets Money saving Shabbihaus retrofit sustainability Using less energy

My Shabbihaus eco retrofit project part 2 Boiler replacement

This came about through problems with the old boiler rather than careful planning. Firstly I replaced the thermostat with a Smart controller, this was about 5 years ago and the choice was limited but I got an Owl controller which allowed us to control the heating with a smart phone.

This allowed us to monitor electricity use as well as program the boiler simply online and turn it off for holidays etc. The controller was easy to fit as you replace the existing thermostat and use the same wiring. Once this was done the heating started coming on only when the temperature in the house fell below the required temperature we set. The previous controller turned on the heating when it was programmed to, regardless of the internal temperature and waited for the thermostat to turn it off again. This fine control and ease of use saved us 10% on our gas bills straight away.

The monitor really helped us concentrate on electricity use around the house and focus on reductions, however it also coincided with having kids and being at home a lot more so our usage actually went up for each successive year, as shown below. Now they are a bit bigger we are out more and using the meter to concentrate their minds too and starting to take our usage down again:

The boiler was an old Worcester and only about 64% efficient. A fault developed with it so it started heating up radiators whenever we used the hot water so we decided to get rid of it. I did plenty of research and luckily enough this coincided with Ecobuild so I was able to go round stalls there to look at a good range of boilers and ask silly questions. Efficiency of most boilers is well over 90% so my main concerns were how it would fit in my kitchen and reliability. I eventually settled on an Intergas boiler, not quite so common in the UK but it came with a 10 year guarantee and has very few moving parts and good reliability.


Very pleased with the boiler and five years later there have been no problems. We are warmer, the shower works better and our gas bills went down.

Very pleased with the boiler and five years later there have been no problems. We are warmer, the shower works better and our gas bills went down.

We also got TRVs installed on all the radiators.

Categories
Money saving Projects Shabbihaus retrofit sustainability Using less energy Using less water

My Shabbihaus eco retrofit project – part 1 introduction

Many of you, like me, will have listened watched or read about a wonderful renovation project where the house has become a wonderful palace of efficiency, costs 10p a year to heat and it’s the most comfortable and relaxing place in the world. You gaze on in envy at the ventilation, triple glazed windows and wonderful insulation. Then comes the tipping point, what did it cost for this the interviewer asks? ‘Oh, only £80,000 on top of the cost of the building work’ and at that moment you realise this is never going to happen in your home.

So, what can you do without breaking the bank? I thought I would share some of my experiences of trying to improve my property on a tight budget, with a low income and the property occupied throughout.

Ideally you would start with a whole house plan for your property, this includes an assessment of the general condition of the place and a list of all the efficiency improvements that it is possible to make to the property. You don’t need to carry them all out and certainly not all at once but it gives you a path for the next 10 years or so, you can also tie this in to any other projects you are planning, redecoration, extensions etc. You can see mine here.

Of course I didn’t start with this, I started when the boiler broke but I have got round to it now and I don’t think I got too far off course. The other thing you should probably do is monitor the conditions in the house so you can get a picture of it’s performance and the effect of the changes you make. I have been even worse at this but have some stats on energy use  that the smart meter collected, otherwise it comes down to ‘we felt warmer’ and ‘the mould didn’t reappear on the walls’. Still I am quite happy and it’s slowly getting more comfortable.

So, what did I and what did it cost, here we go in chronological order with the points where it coincided with other works, details to follow over the next couple of weeks